Mighty Therm AP Anleitung zur Fehlerbehebung

Stöbern Sie online oder laden Sie Anleitung zur Fehlerbehebung nach Oberirdisches Schwimmbadzubehör Mighty Therm AP herunter. Mighty Therm AP Troubleshooting guide Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 28
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
Installation and Operation Instructions Document 3006T
H0067300T
Model AP
Sizes 500 - 1825
These instructions are to be stored in the
pocket provided on the heater.
Installation and Operation
Instructions for
Mighty Therm
Pool Heating Boiler
WARNING
I
f the information in this manual is not
followed exactly, a fi re or explosion may
result causing property damage, personal
injury or loss of life.
Do not store or use gasoline or other
ammable vapors and liquids in the vicinity of
this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electrical switch; do not
use any phone in your building.
Immediately call your gas supplier from a
nearby phone. Follow the gas supplier's
instructions.
If you cannot reach your gas supplier, call
the fi re department.
Installation and service must be performed
by a qualifi ed installer, service agency, or gas
supplier.
FOR YOUR SAFETY: This product must be installed and serviced by a professional service technician,
qualifi ed in hot water heater installation and maintenance. Improper installation and/or operation could
create carbon monoxide gas in fl ue gases which could cause serious injury, property damage, or death.
Improper installation and/or operation will void the warranty.
AVERTISSEMENT
Assurez-vous de bien suivres les instructions
données dans cette notice pour réduire au
minimum le risque d’incendie ou d’explosion ou
pour éviter tout dommage matériel, toute blessure
ou la mort.
Ne pas entreposer ni utiliser d’essence ni d’autres
vapeurs ou liquides infl ammables dans le voisinage
de cet appareil ou de tout autre appareil.
QUE FAIRE SI VOUS SENTEZ UNE ODEUR DE GAZ:
Ne pas tenter d’allumer d’appareils.
Ne touchez à aucun interrupteur. Ne pas vous
servir des téléphones dansle bâtiment où vous
vous trouvez.
Appelez immédiatement votre fournisseur de
gaz depuis un voisin. Suivez les instructions du
fournisseur.
Si vous ne pouvez rejoindre le fournisseur de
gaz, appelez le sservice des incendies.
L’installation et l’entretien doivent être assurés par un
installateur ou un service d’entretien qualifi é ou par le
fournisseur de gaz.
Seitenansicht 0
1 2 3 4 5 6 ... 27 28

Inhaltsverzeichnis

Seite 1 - Mighty Therm

Installation and Operation Instructions Document 3006TH0067300TModel APSizes 500 - 1825These instructions are to be stored in thepocket provided on t

Seite 2 - Table of Contents

LAARS Heating SystemsPage 10after the pump shuts off will not siphon chlorine solution into the heater.4. When the operation of a chlorinator is su

Seite 3 - General Information

Mighty Therm Commercial Pool Heating BoilerPage 11Figure 11 - Control LocationsRating PlateManualPilotValveWaterCirculatingPumpSafetyGasValveOperating

Seite 4 - Installation

LAARS Heating SystemsPage 12and the chemical balance of the water has been adjusted to a stable pH of 7.2 to 7.8. After the pool water is fi ltered,

Seite 5

Mighty Therm Commercial Pool Heating BoilerPage 132. Manual Hi-Limit Checkout. The manual high limit capillary bulb is installed at the heater outlet

Seite 6

LAARS Heating SystemsPage 143. To ensure that the spa inlet water does not exceed 104°F (40°C), the spa fi lter pump must circulate at the minimum fl

Seite 7 - 2.4 Gas Supply and Piping

Mighty Therm Commercial Pool Heating BoilerPage 15Section 4Maintenance1. Inspect the pump seal every 6 months. Replace the pump if the seal shows sig

Seite 8 - 2.5 Electrical Wiring

LAARS Heating SystemsPage 16 The general recommendations include keeping the water chemistry stable within the following guidelines:pH: 7.2 to 7.8F

Seite 9 - and Installation

Mighty Therm Commercial Pool Heating BoilerPage 171. Symptom: heater is pounding, knocking or emitting steam from relief valve Possible Cause Wha

Seite 10 - Operation

LAARS Heating SystemsPage 18Section 6 Parts Description and Order NumbersJacket and Combustion Chamber Components1 Top Panel Assembly 1053570

Seite 11 - 3.2 Initial Start-Up

Mighty Therm Commercial Pool Heating BoilerPage 19Figure 17. Parts Identifi cation.ONE PIECEPUMP VOLUTE

Seite 12 - LAARS Heating Systems

LAARS Heating SystemsPage 2Table of ContentsSection 1General Information1.1 Introduction ...31.2 He

Seite 13 - 3.6 Spring and Fall Operation

LAARS Heating SystemsPage 2025 Drafthood, Relief Baffl e, Right 10540901 10540902 10540903 10540904 10540905 10540906 10540907 10540908 1054090926 D

Seite 14 - 3.9 Therapeutic Pools (Spas)

Mighty Therm Commercial Pool Heating BoilerPage 2136 Baffl e, Heat Exchanger {8-Tube} 10534601 10534602 10534603 10534604 10534605 10534606 10534607

Seite 15 - Maintenance

LAARS Heating SystemsPage 2251 Pump Housing {Glassed Cast Iron} 10261501 10261501 10261501 10261501 10261501 10261501 10261501 10261501 10261501 Pum

Seite 16 - Troubleshooting

Mighty Therm Commercial Pool Heating BoilerPage 23 Safety Gas Valve, On-Off {LP} V0046600 V0046600 V0046600 V0046600 V0046600 V0046600 V0046700 V004

Seite 17

LAARS Heating SystemsPage 24Figure 18 - Tile AssembliesWhen ordering tiles: Assembly number isfor all tiles. Part numbers shown for the front of uni

Seite 18

Mighty Therm Commercial Pool Heating BoilerPage 25Figure 19 - Outdoor Parts1234567891011121415161718191320

Seite 19 - PUMP VOLUTE

LAARS Heating SystemsPage 26 Outdoor Jacket, Combustion Chamber, Heat Exchanger Components Refer To Figure 19 For Placement5 Rear Panel, Flue Coll

Seite 20

Mighty Therm Commercial Pool Heating BoilerPage 274 Upper Rear Panel 10658701 10658702 10658703 10658704 10658705 10658706 10658707 10658708 106587

Seite 21

H0067300T800.900.9276 • Fax 800.559.1583 (Customer Service, Service Advisors)20 Industrial Way, Rochester, NH 03867 • 603.335.6300 • Fax 603.335.33551

Seite 22

Mighty Therm Commercial Pool Heating BoilerPage 3Section 1General Information1.1 IntroductionThis manual provides information for the installation and

Seite 23

LAARS Heating SystemsPage 4Section 2Installation2.1 Heater PlacementThe pool heater must be placed to provide specifi c clearances on all sides for m

Seite 24

Mighty Therm Commercial Pool Heating BoilerPage 5Figure 4 - Typical Heater Installation on Roof Using 4x4 StringerFigure 5 - Installation on Concr

Seite 25 - Figure 19 - Outdoor Parts

LAARS Heating SystemsPage 6direction of fl ow. A vent connector should be supported for the design and weight of the material used to maintain cleara

Seite 26

Mighty Therm Commercial Pool Heating BoilerPage 77. Tout mauvais fonctionnement du systéme dʼévacuation commun devrait être corrigé de façon que lʼin

Seite 27

LAARS Heating SystemsPage 8Before operating the heater, the complete gas supply system and all connections must be tested for leaks using a soap sol

Seite 28 - H0067300T

Mighty Therm Commercial Pool Heating BoilerPage 9Auxiliary Time Clock Wiring:If a time clock is used to control the fi lter pump operation, a separate

Kommentare zu diesen Handbüchern

Keine Kommentare